LFS Single 300ml Wall-Mounted Bottle Holder Chrome

The LFS Single 300ml Wall-Mounted Bottle Holder is a revolutionary new Tamper Proof Dispenser has been specially created to improve on current designs (and imperfections) of dispensers available from other providers. Imagine - no chance of tarnish or rust to spoil your clients' impression of your standards. No loss of toiletries products, because of loose or easily removed bottles. This stylish stainless steel bracket is the perfect complement to any bathroom decor or cloakroom. Select from fragrant dispenser products by luxury range.

At last a hygienic and elegant method of dispensing toiletries - without nasty leaks or mess. The Tamper Proof Dispenser bracket is available with an array of branded 300ml luxury toiletries. Perfect for your spa area, gym, cloakrooms, or guest bathrooms - the Tamper Proof Dispenser is easy to install. Width (Bottle Fitting): 6.2cm H:Adjustable.

300ml Wall-Mounted Bottle Holder Features

• The revolutionary new Tamper Proof Dispenser has been specially created to improve on current designs (and imperfections) of dispensers available from other providers.
• Imagine - no chance of tarnish or rust to spoil your clients' impression of your standards.
• No loss of toiletries products, because of loose or easily removed bottles.
• This stylish stainless steel bracket is the perfect complement to any bathroom decor or cloakroom.
• Select from fragrant dispenser products by luxury range.

Please check your bottle size prior to ordering.

Fixing We highly recommend using plugs and screws to secure your holder. Tape can be used if applied to a clean smooth surface, however we recommend using a silicone adhesive in concurrent with the tape, do not rely on the tape alone. Clean the surface with the alcohol wipe provided making sure its dry before applying your holder.
Note LFS does not install holders nor guarantees any of the fixings or tape supplied, due to different surface types. The fixing method of the holder is down to the purchaser.
Hand Basin Location Fit allowing suitable height above and below holder for access for re-filling and changing the bottle. Recommended minimum height from work surface to bottom of holder = 10cm.
Shower Location If possible, locate the holder arms reach from shower head, not directly beneath it. We recommended a minimum height of 100cm from floor to bottom of holder and if possible fit dispenser into a corner so not to be a hazard.

Loading Holders

1. Loosen screws with allen key.
2. Load bottles by positioning pumps through large holes in the front plate that lifts up.
3. Once bottles are positioned lower the front plate until it rests on the shoulder of the bottle/bottles, then tighten screws, your bottles should now be secure.

Note Some pumps may be too large to go through the top holder holes, so these may have to be removed first.
Topping-Up Remove pump and top-up, bottles only need to be removed when cleaning or changing.

Cleaning For care of your holder, we recommend removing bottles monthly and clean thoroughly using a micro fibre cloth and soapy water. If positioned in hard water areas, white vinegar or lemon juice is recommended for removal of lime scale. Harsh chemicals or abrasive cleaners should not be used to clean these holders, these may cause damage to the surface.

Warranty: Our holders are guaranteed for two years against manufacturing defects or operation. Holders are not guaranteed against misuse of cleaning. LFS does not guarantee the fixings supplied, the purchasers own fixings, or the installation whatsoever. If necessary, seek professional advice prior to installation.

For maximum presentation keep bottles topped up at all times.