Enov Q010 Graffiti Remover Full Power 5 Litre
- Full Power graffiti remover for porous surfaces which removes spray paint on the first pass, removing the need for harsh antighosting products.
- The Enov Full Power gel sits on the surface and breaks the graffiti up without dissolving it.
- This prevents the graffiti from soaking into the wall.
- The broken up flakes of paint are then easily removed with a pressure washer without leaving any ghosting.
- Removes graffiti from brickwork, breezeblock, stone and any solvent resistant surface.
Full Power graffiti remover for porous surfaces which removes spray paint on the first pass, removing the need for harsh antighosting products.
Graffiti Remover. For Porous Surfaces.
Perhaps the biggest step forward on conventional products.
Conventional equivalent products use solvents like NMP to dissolve graffiti and turn it into a wet slurry, this only serves to allow the graffiti to soak
further into the wall or run down the brickwork, spreading the staining further. The Enov Full Power gel sits on the surface and breaks the graffiti up
without dissolving it. This prevents the graffiti from soaking into the wall. The broken up flakes of paint are then easily removed with a pressure washer
without leaving any ghosting.
Full Strength graffiti remover. Removes graffiti from brickwork, breezeblock, stone and any solvent resistant surface. Does not generate "shadows". Full Power is available in bulk for painting / roller coating or in 2 sizes of aerosol. The 750ml can is equipped with a high discharge valve and wide angle button to facilitate an 18 inch wide spray covering 3sq feet in only two seconds. Only a single coat of product is necessary. For smaller areas the 500ml can has a regular valve and button.
Compatibility: Bare metal, Brick, concrete, breezeblock and stone, Bare wood (untreated), Polyethylene, Polypropylene, Any other plastic, (will damage) Polycarbonate, (will damage) Treated wood e.g. outdoor fencing, (may attack treatment) Paint (any type), (will remove) Varnish (any type), (will remove) Fabrics e.g. cloth, carpet, (will damage)
Spray product evenly across graffiti. The product will adhere to the graffiti, and break up the film so it will wash off the surface. There is no traditional solvent action, the gel will not dry out. Contact time of up to 1 hour can be expected though less aged graffiti will remove much quicker. Scrub briefly with a stiff brush prior to removing with a pressure washer. On non-porous surfaces, such as metal, the graffiti can be scraped or wiped off with a paper towel. After rinsing apply Power Off sacrificial coating for long term anti-graffiti protection.
-Composition A blend of oxygenated solvents, surfactants and rheology modifiers
-Appearance Hazy gel
-Fragrance Low solvent
-Stability Two years minimum
Biodegradability All surfactants contained in Our Products meet the requirements of the EU Detergent Directive 2005 / 2004/648/EC. This requires all surfactants to break down both quickly and completely into harmless material such as CO2 and water.
All images used are for illustrative purposes and are not intended to be relied upon for, nor to form part of, any contract unless specifically incorporated in writing into the contract.
Alliance UK reserves the right to change product images at any time without notice.